i-Sense monitors are low cost, easy to use, easy to install and virtually maintenance-free.
Once installed, the i-Sense transmits your power quality event data to our i-Grid servers
via an Ethernet connection. That data is collected, analyzed and sent to subscribers
in the form of
— giving you the ability to view detailed power quality event data and reports anytime,
anywhere, using any computer with an Internet connection, even your cellphone or pager.
Contact i-Grid Support for other nominal voltages.
50/60 Hz Auto-sensing
Event Detection by RMS voltage deviation and adaptive wave shape deviation algorithm
Periodic logging of 10 minute min/max/avg RMS voltage samples
Storage for over 300 events (nonvolatile memory event storage)
Web-based Management Console for easy setup
Long life internal battery allows outage notification
Event timestamps are synchronized to UTC (NIST Reference)
Conveniently configure your i-Sense prior to installation with a power adapter
available through Digi-Key.
Order one of the following Digi-Key part numbers:
You can also use any power adapter that fulfills these minimum specifications:
Input voltage is suitable for the country of installation.
Output voltage and regulation
must be 9.0vdc with 5% regulation.
Unregulated supplies can damage the unit.
Output current must be at least .66A (higher is ok).
Connector length must be at least 9.5mm.
Connector outer diameter must be 5.5mm (inner diameter 2.1mm).